| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Engine/Hybrid System | Section: Lubrication | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002MQJ00FX |
| Title: 3UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION (2008 Sequoia) | ||
ON-VEHICLE INSPECTION
1. CHECK OIL QUALITY
(a) Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil and filter
.
2. CHECK ENGINE OIL LEVEL
(a) Warm up the engine, and then stop the engine and wait for 5 minutes.
(b) Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add oil up to the full level mark.
NOTICE:
Do not fill engine oil above the full level mark.
3. INSPECT OIL PRESSURE
(a) Remove the oil pressure sender gauge
.
|
(b) Install an oil pressure gauge. |
(c) Warm up the engine.
(d) Inspect the oil pressure.
Standard Oil Pressure:
|
Condition |
Specified Condition |
|---|---|
|
Idle |
70 kPa (0.7 kgf/cm2, 10.1 psi) or more |
|
2500 rpm |
220 kPa (2.2 kgf/cm2, 32 psi) or more |
If the pressure is not as specified, check the oil pump
.
(e) Remove the oil pressure gauge.
(f) Install the oil pressure sender gauge
.
|
|